|
|
|
Model |
CN-800-12 |
CN-800-15 |
CN-800-24 |
CN-800-48 |
|
DC Voltage |
12V |
15V |
24V |
48V |
|
Voltage Tolerance |
㊣1% |
㊣1% |
㊣1% |
㊣1% |
|
Rated Current |
66A |
54A |
33A |
16.6A |
|
Current Range |
0ㄜ66A |
0ㄜ54A |
0ㄜ33A |
0ㄜ16.6A |
|
Rated Power |
800W |
800W |
800W |
800W |
|
Ripple & Noise |
150 mVp-p |
150 mVp-p |
240mVp-p |
480mVp-p |
|
DC Adjustment Range |
Can adjust from 20%~100% output voltage by external control 1-5V |
|
Setup,Rise,Hold Time |
800ms, 50ms, 16ms at full load | |
| INPUT |
|
| Voltage Range |
90‵130VAC / 180‵260 VAC47‵63 Hz˙selected by switch 260‵370VDC |
| AC Current |
13A/115 VAC 8.0A/ 230 VAC |
| Efficiency |
80%(HSCN-800-12); 81%(HSCN-800-15);85%(HSCN-800-24); 87%(HSCN-800-48); |
| Inrush Current |
60A/230V |
| Leakage Current |
3.5 mA/240VAC |
| PROTECTION |
|
| Over Load |
110%‵135% |
|
Protection type: Current limiting, delay shut down o/p voltage, re-power on to recover |
| Over Voltage |
110%~135% |
|
Protection type: Shut down o/p voltage, re-power on to recover |
| Over Temp. |
TSW1(Power transistor) When temp. >100 ⊥, shut down o/p voltage, re-power on to recover |
| ENVIRONMENT |
|
| Working Temp., Humidity |
-10⊥‵+65⊥ㄛ20%‵90 %RH |
| Storage Temp., Humidity |
-20⊥‵+85⊥ㄛ10%‵95 %RH |
| Vibration |
10‵200Hzㄛ2G 10min./1cycle, period for 60min, each along X, Y, Z axes |
| SAFETY |
|
| Withstand Voltage |
I/P-O/P, I/P-FG:1500VAC |
| Isolation Resistance |
I/P-O/P, I/P-FG, >100M Ohms / 500VDC |
| STANDARD |
|
| Safety Standard |
Design UL1950,CSA22.2,IEC60950 |
| EMC Standard |
Design refer to FCC Part 15 Class A |
| OTHERS |
|
| Weight |
2.3Kg; |
| Packing |
8pcs/24.0kg/CARTON |
| NOTE |
1.All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25⊥ of ambient temperature.
2.Ripple & noise are measured at 20MHz of bandwidth by using a 12∪twisted pair-wire terminated with a 0.1米 &47米 parallel capacitor.
3.Tolerance: includes set up tolerance, line regulation and load regulation
4.The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. | | |
Miss.Wu
